Sale!
TP4056 Charging ModuleTP4056 Charging Module

TP4056 Charging Module with Battery Protection Circuit

৳ 38.00

  • Micro USB Input Charging Port.
  • Voltage Supply (Vs) : 4V ~ 8V
  • Charge Voltage termination (accuracy) : 4.2V (1.5%)
  • Supply current (Rprog=1.2k: 1A chrg) : 150uA (typ)
  • Supply current (Chrg ended/ shutdown) : 55uA (typ)
  • Ibat (Rprog=1.2k: 1A chrg ) : 1050mA (max)
  • Ibat (Stand by mode; Vbat = 4.2V) : -6uA (max)
  • Vtrckl(Rprog=1.2k: Vbat:rising) : 2.9V (typ)
  • Itrckl (Rprog=1.2k: Vbat<Vtrckl ) : 140mA max)
  • Vtrhsy(Rprog=1.2k) : 80mV (typ)
  • Operating temperature : -40°C ~ 85°C

Description

TP4056

The TP4056 chip is a lithium Ion battery charger for a single cell battery, protecting the cell from over and under charging. It has two status outputs indicating charging in progress, and charging complete. It also has a programmable charge current of up to 1A.

You can use it to charge batteries directly from a USB port since the working input voltage range is 4V ~ 8V.

The fee should separate the load OUT terminal on the positive and negative can not be wrong, please according to specifications, otherwise it will damage directly.
The first time access to the battery, there can be no voltage between the output OUT + and OUT-, then access 5V voltage charge your energy can activate the protection circuit, and the battery from the B + B-, then draw a line The short open also need to be recharged to activate the protection circuit. Notice that the charger must be able to output 1A or more when you input a cellphone charger, or cannot charge
+ MICRO USB female and next-pads for the power input, access 5V. B + positive then the lithium battery, B-then negative lithium batteries. OUT + and OUT- connected to the load, such as positive and negative electrodes connected to mobile booster plate or other load.
Connect the battery to the B + B-, inserted into the USB female mobile phone charger, the red light is charged, the green light too full.
Inputs with MICRO USB female, can be input directly to do with the phone charger lithium battery,
And still the input voltage wiring pads, can be very convenient DIY
Input voltage: 5V
Charging cut-off voltage: 4.2V ± 1%
Maximum charging current: 1000mA
Battery over-discharge protection voltage: 2.5V
Battery over current protection current: 3A
Board size: 2.6 * 1.7CM

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.